@Fozi nope none of them worked for me very surprising.
Read the statement by Michael Teeuw here.
Posts made by bachoo786
-
RE: UPDATE: Replaced my PIR-Sensor with a Doppler Microwave Sensor.
-
RE: UPDATE: Replaced my PIR-Sensor with a Doppler Microwave Sensor.
@Fozi Hi
I am on raspberry pi 4 and I think wiringPi does not work with it as the guy has stopped developing it any further. Is there any other way I could make this work?
Thanks.
-
RE: Bathroom Magic Mirror
@spitzlbergerj thank you for answering.
-
essentially its the silicone thats holding the mirror currently, I mean the groove does support it and hold it tight also. The reason why I asked about the groove is because I wanted to use the silicone alone and as you mentioned that the silicone is not see through or staining the mirror so you could use essentially alot of silicone to stick it to the back panel.
-
that makes sense.
-
I was under the impression that the mirror has to be covered with even blackness from one side in order for it to display the correct non distorted image on the mirror, so even the slightest can cause the image to distort especially around the groove in your case.
How big is the frame? and how much do you think it would roughly cost to ship it to the UK? if its not worth it then can you tell me how you made the groove on the wood? I mean like you mentioned the groove holds the mirror stronger in addition to the silicone.
-
-
RE: Bathroom Magic Mirror
@spitzlbergerj hi well done and looks amazing.
Quick question:-
Can you not glue the mirror using the silicone on the back panel directly? Rather using the groove in the wood? Is it possible?
-
The back panel how is it holding the monitor? I read your comment that you have your back panel cut around the monitor and it fits in perfectly and tightly. How and where did you apply the glue tape ?
-
Finally do you have any distortions of your image from your mirror? Especially around the edges where you have your silicone in the groove and the mirror? Because the blackness of the groove is different from the back panel and as well as the monitor?
Thanks.
-
-
RE: UPDATE: Replaced my PIR-Sensor with a Doppler Microwave Sensor.
@Fozi so I got a new radar sensor set the resistance to 80ohms which would give me around 40 to 50cm detection distance. I am using @cowboysdude script.
My mm is running on my rpi 4b 4g and at present its connected to my TV. However the rada sensor is not working as the script is meant to detect motion and if there is no motion it would turn the tv off after 20 seconds. I tried many times but have failed.
Any ideas? Or maybe my sensor is not working. Is there a simple script that I could test the sensor?
Thanks.
-
RE: UPDATE: Replaced my PIR-Sensor with a Doppler Microwave Sensor.
@Fozi Hi
Can i solder pin 1 and 2 of the resistor to the radar sensor? I accidentally broke pin no 3. -
RE: My Smart Mirror
Amazing @BreakBeatJunkie well done. Do you mind sharing the components and how you put everything together please?
Thanks.
-
RE: How to hide Splash screen on boot or edit Splash screen on boot?
@schlachtkreuzer6 how do you change the image? In which folder is the image?
-
RE: (electron:2910): Gtk-WARNING **: 14:16:40.324: cannot open display: :0
@sdetweil I had to add the following in my config.txt and it works now.
hdmi_force_hotplug=1 hdmi_ignore_edid=0xa5000080 hdmi_group=2 hdmi_mode=81
do you mind sharing your /boot/config.txt please?
Also after doing these settings the raspberry pi doesnt connect to wifi.
Its a disaster this rpi 4 tbh