"npm run start" does not work. Returns "sh 1 ./node_modules/.bin/electron not found"

[sdetweil]

@tony-72 well, what a mess

the full (recommended) 64bit image for me boots to a Busybox prompt, tried 3 times w the rasp imager and another …

SO, had to do the other 64 bit image (not full)

then I had sd card problems… (I was working on my pi4 behind the 7 in touch screen which crashed the other day after a power failure… ) that sd card is trash

so I used another… SO slow… (sd card toast)
so I used ANOTHER… finally…
but apt has some problem so reflashed AGAIN

this time it installed correctly…

BUT… I didnt see the problems you meantioned at all

this is the image I used

[tony-72]

I appreciate all the hard work and assistance. So I believe it is working now. So I rebooted the Raspi and when it came up it showed there were updates. I allowed those updates to install. I then went into terminal and sudo update/sudo upgrade. After that, your script worked as advertised.

Now I did not get through it all until this morning and have not been able to launch it again. I do know the pm2 works because it kept restarting MM every few seconds when I was trying to shut down the Raspi. I will mess with it tonight after i figure out how to disable the autostart. I believe it was “pm2 stop mm” or “pm2 stop MagicMirror”.

[sdetweil]

@tony-72 pm2’s job is to keep the app running, so if it crashes pm2 restarts

pm2 stop all

pm2 logs --lines=50

to look at the logs

i strongly suggest stopping pm2 use while you install and test modules

use npm start in the MagicMirror folder, ctrl-c to end, or ctrl-q on the browser

this way you can see the messages from npm start easier

[tony-72]

Awesome and thanks, everything working as advertised at the moment. About to attempt my first module install and config. Question, is there a text editor installed with your script? I was trying to figure out how to get VScode installed and where to install it, then realized there may be one on here already. What do you suggest, I have zero coding experience but I understand the concept and know a little from studying Cybersecurity.

[sdetweil]

@tony-72 nano is the built in text editor, its text only

vscode goes in system folders, has nothing to do with MM

you could try my MMM-Config module which generates a form for config…
https://github.com/sdetweil/MMM-Config

also see this
https://forum.magicmirror.builders/topic/19193/best-way-to-develop-from-windows-machine

see the first link in my sig below for installing modules… (I didn’t write it)