Read the statement by Michael Teeuw here.
disable NO signal message
-
@bhepler , But when i want to keep my raspberry always online i have to do something about this situation, it is possible to put new firmware on the TV but i can`t find any modding software thats easier then Hexa codes to configure…
with an LG tv its possible because u can get the firmware software download on a USB drive from the TV, but i want to use a tv that i don`t use anymore.(Recycle project).
-
@aboulezz said in disable NO signal message:
I faced the same problem with my LG screen but found a work around.
Step 1) I used wiringpi.com and modified the simple blink example to send out just one impulse:
#include
int main (void)
{
wiringPiSetup () ;
pinMode (0, OUTPUT) ;
digitalWrite (0, HIGH) ; delay (200) ;
digitalWrite (0, LOW) ;
return 0 ;
}Step 2) I modified the PIR modules’ node_helper.js so within the functions activate / deactivate don’t enable/disable the HDMI output but execute my compiled ‘blink’ command.
Step 3) I hard - wired the singal pin to the (with resistor / transistor) to the screens power-button.
done :-)
Can`t i use this instead and make my raspberry a longer time to get the HDMI port visible to the TV, ore do i get the message still when giving the HDMI port a command to show himself. (If u know what i mean).
