Read the statement by Michael Teeuw here.
Powering my mirror?
-
My problem with it was that I didn’t want to have the brick of it out side the case. Or 3 foot of wire looped inside but I’ll have to cut it to add the step down anyway. So I may as well try it that way first. But I also didn’t know if it was big enough for both To run off of.
-
i ran into this problem awhile back but got put on the backburner.
-
@The-Bean Whats the buck down converter? I guess the pi is just a to big load for it
Never expect those china buck down converters to achieve more than 50% of what they say they will do (especially without additional cooler)
-
@The-Bean you might want to try with a additional cooler on the converter since the pi is not constantly pulling 2A, so it might work
-
-
@The-Bean When it gets really hot I would try with a heatsink
and what happens when you connect it and then turn up the voltage until you reach 5V? -
the converter its self doesnt really get hot.(that i have noticed) it just the wire to the pi. and once it drops, it doesnt adjust anymore.
-
hm strange I mean I don’t know the cable size you use, but 5V 2A is pretty much nothing for any cable. Should not really get hot for sure
-
thats what i thought… i will continue to investigate and post back if i find anything.
-
2A is not nothing for a thin cable. What kind of cable are you using? If it is just a very thin one, it would also explain the huge voltage drop. Try using a thicker one.
I am running the Pi with a SSD with one of those very cheap china buck converters without any issues for 6 months now. -
Yep thats why I write I don’t know what siye of a cable you use ;)
but since I expected the cable to be very short (step down converter directly in front of the pi and the cable is probably open to all sides
VDE rules say you should use at least 0.5mm² up to 2.5A 2m
and at least 0.1mm² up to 1A 2mSo you should use 0.5mm² to be on the safe side.
0.25mm² should probably work aswell when you do not have long cables and do not stress the pi fully out to 2A ;)
But yes @MadScientist is right you should definetly not get below thisand keep in mind those values are for copper cables. If you use aluminium cables you obviously need thicker cables
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login