Read the statement by Michael Teeuw here.
Display sendet "Kein Signal" anstatt sich auszuschalten
-
Thanks.
The Pir is also working fine in my case.
I’m going to buy a relay and then i will see.Kind regards
-
Konnte das Problem mittlerweile gelöst werden?
Ich habe nämlich das gleiche Problem und überlege auf ein anderes Board umzusteigen ein VGA Board von Pollin evtl. kann dies das Problem lösen.
LG
-
If it is still in progress. Use this board:
https://www.pollin.de/p/lvds-interface-pi-mt6820-vga-zu-lvds-810220
5€and it is working perfect!
Best,
MaxxMagic
-
@MaxxMagic said in Display sendet "Kein Signal" anstatt sich auszuschalten:
MaxxMagic
Hello MaxxMagic, that sounds very good. I also tried to turn off my mirror with the T.V56 board via the PIR module, which doesn’t work, the display stays live and lights up like a bedside lamp. Switching it on again is only possible with the remote control of the T.V56 board.
Can you tell me about your suggestion of the LVDS interface PI-MT6820, VGA to LVDS, how to connect it afterwards? Do I also have to order a cable in the shop?Greeting
antibraatz -
Hey @Antibraatz ,
if you used these old typical board T.V56 you can use the old cable. But can you give me the specs of your display than we could have a look, because I think the board just supports 8bit.
But I’m not an expert.
Best,
MaxxMagic
