UNSOLVED Display sendet "Kein Signal" anstatt sich auszuschalten
-
@MaxxMagic said in Display sendet "Kein Signal" anstatt sich auszuschalten:
MaxxMagic
Hello MaxxMagic, that sounds very good. I also tried to turn off my mirror with the T.V56 board via the PIR module, which doesn’t work, the display stays live and lights up like a bedside lamp. Switching it on again is only possible with the remote control of the T.V56 board.
Can you tell me about your suggestion of the LVDS interface PI-MT6820, VGA to LVDS, how to connect it afterwards? Do I also have to order a cable in the shop?Greeting
antibraatz -
Hey @Antibraatz ,
if you used these old typical board T.V56 you can use the old cable. But can you give me the specs of your display than we could have a look, because I think the board just supports 8bit.
But I’m not an expert.
Best,
MaxxMagic
