MMM-PIR-Sensor problems

Charley · Apr 15, 2018, 4:23 PM

@Charley said in MMM-PIR-Sensor problems:

powerSavingDelay:40

You may want to change your config to only: powerSavingDelay:40

If you switch off thru HDMI then powerSaving:true is not needed imho.
and better use powerSavingDelay: 60 instaead of offDelay just copy mine config.js settings from above it should work

blebbens · Apr 15, 2018, 4:50 PM

Okay, I changed to your config.js-settings.

Not sure if I have connected the cables correctly RPIPIR.

According to github, default is pin#22 (BCM).
Since the beginning I connected the data cable to pin#22/GPIO 25.
But, github is telling BCM22 should be default, so I now connected it to pin#15/BCM22.
Tried to find correct pins using the scheme above.

Charley · Apr 15, 2018, 4:54 PM

I have just checked my Mirror I am at pin 22
The 8th pin on the bottom

blebbens · Apr 15, 2018, 4:58 PM

Yes, it is connected to the 8th bottom from the left…

Building the mirror, setting up the pi and magic mirror with modules - no problems… until trying to use the PIR…

HDMI signal is sending still in blank screen… magic mirror does not turn back on… it still does not care about the PIR.

at what position are your potentio meters and the jumper ?

Charley · Apr 15, 2018, 5:10 PM

My PIR has no jumper. From banggood
The two potentiometers are both in the middle position.
There are a few more topics on the screen not reacting properly a few LCD screens do not support switching thru HDMI.

I tested the PIR on an Arduino Nano to see when it was detecting and at what range, but you can also do that with a Raspberry.

blebbens · Apr 15, 2018, 5:14 PM

Normally the monitor is switching to standby if there is no signal from HDMI. I think the problem is the Raspberry. Found nothing to fix this.

I am also wondering why magic mirror switches to no signal/blank screen after a couple of minutes. Is there a possibility to change this to a fix number of seconds? Seems as if the MMM-PIR-setting for switching on/off in seconds has no effect.

Charley · Apr 15, 2018, 5:15 PM

Maybe you have screensaver not disabled.

blebbens · Apr 16, 2018, 10:33 AM

Now, screensaver is disabled… PIR not working. Display is switched on all the time…

Perhaps, the problem could be the installed GPIO 2.25 instead of a newer version?
After running npm install wiring-pi version 2.25 is still running.

Charley · Apr 16, 2018, 3:25 PM

You could try if you are using the right GPIO by pulling the pin Up.

Take a 10k Resistor one side on 5V and the other side tap the GPIO pin that is what the PIR would do. Then you can check if you use the proper pin.

blebbens · Apr 16, 2018, 4:38 PM

I am sure I am using GPIO22.

I am wondering about the display, which is not switching off. It stays on all the time.

Could it be a problem with the fact that the user “pi” is logged in ?

Why does the display not switch off ?