Read the statement by Michael Teeuw here.
Needing help - MagicMirror sometimes working
-
Hi there,
i took my 1-year-old MagicMirror and switched from a Raspberry Pi 3B to a 3B+. I flashed the newest Raspbian Stretch to my SD card and installed MagicMirror 2.41 without any problems.
After installing a couple of modules, I added a python script to crontab for fan controlling in cases of a system temperature over 58 degrees.
I set up the PIR-sensor for switching on/off the monitor behind the mirror using MMM-Display-Controller - it is not a module.
All this hardware and software was working in my old MagicMirror-Setup. The difference from the old to the new MagicMirror is the MagicMirror Version 2.41, Raspberry 3B+ and the fan python script.
The new setup was working fine, too, including the PIR-sensor. But, after running fine for 1-2 boot sequences, it all comes to the same:
- the system boots up into MagicMirror and shows all the working modules. If no one is in front of the mirror, the monitor switches off. If the motion sensor detects a person, a blank screen is coming up, without any modules
- or, the monitor shows half of the modules at various places
- or, the monitor shows all the working modules, but the screen freezes (clock is not counting time etc)
Sometimes, the system is answering via SSH - sometimes, it answers after a couple of minutes.
I am very dissapointed - put a lot of work into this mirror…
Could someone help ?
Why is the new installed system freezing or showing a blank screen after all was working fine ? Are there any known problems with the Raspberry Pi 3B+ ? Is there a log I can post ?Thanks in advance…
-
Anyone?
Monitor is freezing or switching on/off all the time…
