I think this post may be helpful. https://forum.magicmirror.builders/topic/6987/mmm-pir-sensor-problems/10

It appears that you have wired correctly. Although I would use the Red wire on the VCC for power and the black wire to denote ground and the brown wire as the output wire. Thats typically the way wiring is denoted.

I believe that pin 22 is used for the output so double check that. There is also a delay setting in the config.js that the previous thread speaks of that may impact your setup.
Give it a read.

I have ordered a new Micro SD card -16 Gig Class 10 card. That should be large enough and fast enough I imagine. I will repeat the steps to image and use your installer once it arrives. 2 Days from now (Gotta love Amazon Prime).

I will let you know how it goes. Thanks for the information.

I have a Raspberry Pi Zero W and have installed a fresh image of Raspbian Jesse 20017-07-05. Rebooted. Configured WiFi. Changed default password. Set Time , Timezone, Locale. Rebooted.

Then opened a terminal window and copied and pasted the command in the first post to install MM2. Install progressed and I recieved the message Cloning MagicMirror Done! Then I received an error “Unable to install dependencies” . I am using an 8 Gig MicroSD card.
I changed directories to MagicMirror to look for the install.log file, but I cannot find one to upload.