@Bugsounet I have problem with PIR becouse value change automatically.
pi@raspberrypi:~/pir $ node setup
[PIR] PIR v1.0.4 Initialized…
[PIR] Start
[PIR] Sensor read value: 1
[PIR] Detected presence (value:1)
[PIR] Sensor read value: 0
[PIR] Sensor read value: 1
[PIR] Detected presence (value:1)
[PIR] Sensor read value: 0
[PIR] Sensor read value: 1
This value change automatically. No start with hand etc… PIR faulty?
Hello,
i use A2D and working pretty good. But i have trouble with PIR sensor NC-SR501. I set up PIR and countdown working, but after 10-20s reset countdow to 5 minutes. I try change possition on potenciometer (sensitivity/time) on PIR and same trouble. If i disconnect PIR, coutdown work and after 5 minutes black screen.
Do you have idea where is problem? Faulty PIR?
I think that PIR not working correctly, becouse automatically change value, but I do not make any movement in front of the sensor.
If i try test from wiki A2D PIR, value automatically change 1/0, but I do not make any movement in front of the sensor.
I tried change value reverse, and no sollution.
I tried change GPIO on RPI and same problem.
Thanks.
Sorry my mistake.
I consider this module like OUTDATED and deprecied.
If you want an modern Assistant use: MMM-GoogleAssistant and MMM-Assistant2Display extension
I try new version.
I would like use your MMM-AssistantMk2,
now i read then No MMM-Hotword needed in description, but on YT video they use MMM and after instalation use AssistantMk2.
Thank you.
Well I understand. There is an alternative that can work with google assistant?
Hello i have problem with MM.
I build my first MM. Working excelent, but i have problem with module Hotword. I search some manual how inmplement hotword + google assistant. I have issue with install hotword.
Can I use some new alternative module?
