MMM-CalendarExt3 stopped working

[sdetweil]

@redink can u send me the ~/MagicMirror/installers/upgrade.log

ny userid at gmail

[redink]

@sdetweil thanks for taking the time. It’s sent.

[sdetweil]

@redink so, the upgrade went perfectly. no issues.

not sure what is going on yet.

can you show output of

ip addr

[redink]

@sdetweil

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host
       valid_lft forever preferred_lft forever
2: eth0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000
    link/ether b8:27:eb:ee:09:64 brd ff:ff:ff:ff:ff:ff
3: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
    link/ether 00:0f:60:04:20:d4 brd ff:ff:ff:ff:ff:ff
    inet 192.168.1.100/24 brd 192.168.1.255 scope global dynamic noprefixroute wlan0
       valid_lft 45176sec preferred_lft 34376sec
    inet6 fe80::3e7d:5421:775:6ad0/64 scope link
       valid_lft forever preferred_lft forever

[sdetweil]

@redink can you use the Raspi os config to turn off ipv6 addressing for this adapter?

inet6 fe80::3e7d:5421:775:6ad0/64 scope link

one of the workarounds deals with incorrectly picking the network address to connect with given the client network…

[redink]

@sdetweil while messing with raspi-config over ssh, magicmirror lost connection to my wifi. I had to connect a keyboard and reconnect. But, before going back to your last suggestion I did two other things. I updated pm2 (as suggested by some other post). And in the browser console I noticed that I had an error about not being able to locate “CX3_shared.mjs”. I checked the MMM-CalendarExt3 repo, and found that file CX3_Shared/CX3_shared.mjs, which for some reason wasn’t getting pulled by a git pull. I manually copied it in, and the calendar sort of started working.

I should have paid better attention to the documentation, because I would have seen that I needed to run git submodule update --init --recursive to update the submodule.

The reason I say “sort of” is because my family calendar doesn’t show some repeating events, but I need to dig deeper into that.

I really appreciate all your help.

[sdetweil]

@redink the submodule problem is because you didn’t run npm install on the Ext3 module.

ext3 gets its events from the default calendar.

[redink]

@sdetweil yeah, i probably just did a git pull