Dear all, I’ve been using MM for over 1,5 years now. Unfortunately my SD card died yesterday so I took the opportunity to start from scratch. I installed the latest release 2.7.1 on my RBPi 3. using the “Full KMS” OpenGl driver. Unfortunately my PIR Sensor does not work anymore as my display stays on all the time. Interestingly I’m able to turn the display on an off manually via SSH using vcgencmd display_power 0 vcgencmd display_power 1 I already checked the wiring (which I actually did not change from my setup which was working for a long time) and I also checked the signal line of the PIR Sensor. Both are ok. My configuration looks like this: { module: 'MMM-PIR-Sensor', config: { sensorPIN: 23, powerSavingDelay: 15 } }, It would be great if someone could help me out as I’m clearly missing something…

@Kugelfang yes, you will need to install electron-rebuild in that module from the MMM-PIR folder npm install electron-rebuild then run it to force the epoll rebuild node_modules/.bin/electron-rebuild

Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

A New Chapter for MagicMirror: The Community Takes the Lead
Read the statement by Michael Teeuw here.

MMM-PIR-Sensor not working with latest release - display does not turn off

Solved

Troubleshooting

4.2k

S

sdetweil @shgmongohh
last edited by

@shgmongohh too many pir modules

https://github.com/cowboysdude/Pir-Sensor has one
https://github.com/mboskamp/MMM-PIR has one, in callbackscripts folder
Sam

How to add modules

learning how to use css
1 Reply Last reply
Reply Quote 1

Enjoying MagicMirror? Please consider a donation!