Weather not displaying envcanada provider

sdetweil

@lexcyr can I show the mm startup messages

lexcyr

crazylegs

I notice you have provCode commented out in your config file. The envcanada provider requires that parm, so uncomment and see if your problem is resolved.

lexcyr

@crazylegs Already and still not working

sdetweil

@lexcyr using your config, and the MM config set to address:“0.0.0.0”

I see in the dev window

Access to XMLHttpRequest at 
'https://thingproxy.freeboard.io/fetch/https://dd.weather.gc.ca/citypage_weather/xml/QC/s0000620_e.xml' from origin 'http://0.0.0.0:8090' has been blocked by CORS policy: No 'Access-Control-Allow-Origin' header is present on the requested resource.

but using address:“localhost” works ok

lexcyr

@sdetweil Thank you.

you are right it’s working with localhost, but now i don’t know how to make it listen to other interface in the sametime to be able to access to it remotely. :(

sdetweil

@lexcyr try this, not sure

find the ip address of the pi,
ipconfig, look in your router, …whatever way

replace

address:"localhost",

with

address:"???",

like on my machine

address:"192.168.2.106",

where ??? is the ip address

in my MMM-Config, this address choice is in the dropdown list

lexcyr

@sdetweil Just tried it, now i am able to remotely connect to MM but the weither is gone again :(.

sdetweil

@lexcyr bummer

this may need a proxy to get around this… (code change)

joebloe

Hi,
I have the same problem with envcanada provider. I start a fresh installation and it’s always in loading mode.
I use version 2.18.
Do you have a solution ou an eta for a fix ?
Thanks!