Bugsounet and MMM-Pir

sdetweil

@lif I meant MMM-PIR config setup

there are different numbering schemes for GPIO pins and different ways to access

the doc (readme) describes the different choices.

lif

@sdetweil said in Bugsounet and MMM-Pir:

@lif and you are using the correct pin definition
    Pir: {
      mode: 0,
      gpio: 21
    },

Yes, I think so, the pir is connected to pin 40 on the Raspberry pi 3b which I’m sure is GPIO 21

sdetweil

@lif and if you change to mode 1?? which matches your python lib test?

lif

@sdetweil said in Bugsounet and MMM-Pir:

@lif and if you change to mode 1?? which matches your python lib test?

No difference.

I have added a header: “PIR”, line before the config and that is not showing either.

sdetweil

@lif are there any errors listed in the MM startup messages??

if using pm2 to auto start

pm2 logs --lines =xxx

xxx is number of most recent lines to display, default 15,
usually need 100 or more for full message list

lif

@sdetweil said in Bugsounet and MMM-Pir:

@lif are there any errors listed in the MM startup messages??

if using pm2 to auto start

pm2 logs --lines =xxx

xxx is number of most recent lines to display, default 15,
usually need 100 or more for full message list

Thanks for all your help
I think this line might be relevant
0|mm | [2025-03-24 16:54:30.994] [WARN] No /home/pi/MagicMirror/js/…/modules/MMM-Pir/MMM-Pir.js found for module: MMM-Pir.

It’s correct, there isn’t a MMM-Pir.js file in the MMM-Pir directory.

sdetweil

@lif module rules

module name (exact case) = folder name in modules folder
MUST contain at minimum a file name that matches(exact case) of the modulename.js

AND inside that file it MUST contain a module.register(name…)
where name MUST match (exact case) the module name

rkorell

@lif said in Bugsounet and MMM-Pir:

It’s correct, there isn’t a MMM-Pir.js file in the MMM-Pir directory

If you had cloned this repository from @coernel - the MMM-pir.js is missing.
This must be an error.

Nevertheless: I’ve played around with the original version from bugsounet and figured out that editing his “origin” MM-Pir.js was really hard because he has deleted all linefeeds.
Seeking around I found an editable clone of the *.js files (including node_helper) in the src folder of the repository.
This is true for the new clone from coernel …
give it a try :-)

Regards,
Ralf

sdetweil

@rkorell said in Bugsounet and MMM-Pir:

Nevertheless: I’ve played around with the original version from bugsounet and figured out that editing his “origin” MM-Pir.js was really hard because he has deleted all linefeeds.

called minified

rkorell

@sdetweil said in Bugsounet and MMM-Pir:

called minified

:-) never seen this before…
Called minified - for good reasons …