Read the statement by Michael Teeuw here.
nodejs 22.18.0 ??
-
@sdetweil i had the same problem yesterday with bookworm
-
@Assassins did you use my script?
I tested 32 bit on pi3 the other other day
-
@sdetweil but is only install 22.15.0 and not 22.18.0 yesterday on bookworm, and today on trixie
-
@Assassins flash sd card with bookworm , boot sd, run script
-
@sdetweil
bookworm 32bit on a freash install say :
pi@EmptyImage:~ $ sudo npm install n -g
sudo: npm: Command not found -
@Assassins yes, node/npm are not installed
-
@sdetweil
You start by referring to another thread.
Have you even read what I’m writing in this thread??
Read further up, I’m writing that just install 22.15.0 on a fresh install, and you write back, after you wirte “flash sd card with bookworm , boot sd, run script” the another thread say
sudo npm install n -g -
the script, my script will install node/npm at the version we think matches inside electron, if necessary
IF there is a problem, separately, outside my script,
you can use n or nvm to update/change your node version
n requires node and npm to be installed (as they are part of the n install) -
But how can i install 22.18.0 on a fresh install without all the script.
Why does it have to be so much hassle to install MM today, in the past it was MUCH easier to install. -
@Assassins which OS? trixie 32 bit is a mess… stay with bookworm
my script does the job. from the start (not on trixie)
I have tested on pi3 (32) and pi5 (64) and VM (64 bit)
trixie changes the way swap space increase is done and requires a reboot to change (dumb)
so, it runs REALLLLLLLLLLY slow… in small memory systems… PI-02w
