Thank you! So interesting tid-bit. It works on Browser View mode (IP:8080) but on the mirror itself, no changes. I also have trouble with another module. It shows on the Browser, but not at the mirror. It must be something with the Pi Zero image I’m using.
Read the statement by Michael Teeuw here.
Latest posts made by justindp2006
-
RE: MMM-forecast-io -- Localized up to the minute weather
-
RE: MMM-Advent - Advent Candle
Trying to use this module and it works on the web browser remotely viewing the “mirror” but on the LCD itself there is no candle. Any ideas?
-
RE: MMM-forecast-io -- Localized up to the minute weather
Been trying to use this module but the width is taking up almost the whole screen. I’m assuming size needs adjusted in the css file but I don’t know which is causing this. Ideas?
-
RE: How I got my Magic Mirror working on a Raspberry Pi 0 (zero)
OK, so I haven’t confirmed it on this package but was having the SAME EXACT issue with an octoprint setup for my printer. Anyhow I ran
sudo iwlist wlan0 scan
and it sees my network. Here is the kicker though. My network shows up like "MyNetworkHere ". There is a space between MyNetworkHere and the ". I added the space, saved and rebooted and it immediately connected. Hope this helps someone. -
RE: How I got my Magic Mirror working on a Raspberry Pi 0 (zero)
Tried. Think it’s time to toss in the towel. Hours lost to this project. It would be one thing if I was new to all of this or ignorant to programming or pis in general. I just don’t understand and there are no clues. Thanks for the replies.
-
RE: How I got my Magic Mirror working on a Raspberry Pi 0 (zero)
@Mikgabo said in How I got my Magic Mirror working on a Raspberry Pi 0 (zero):
wed as I made it o
I understood :) I tried that earlier and again and there is no networking options under it?
-
RE: How I got my Magic Mirror working on a Raspberry Pi 0 (zero)
I used the image that was posted a few comments back. I can NOT for the life of me get the wireless to connect. I have followed every guide I can find and it will not connect. I have tried DHCP and static. I’m out of ideas.