Many thanks, works a treat.
only outstanding issue is the screen back-light remains on with a glow at night, otherwise all working great.
thank you
Read the statement by Michael Teeuw here.
Latest posts made by eyesallin
-
RE: MMM-PIR since update not working.
-
RE: MMM-PIR since update not working.
@bugsounet
I reverted back to the Rpi4 to see if the screen blanking issue worked better?
Moving forward I think perhaps ill go back to the pi5 then. -
RE: MMM-PIR since update not working.
@KristjanESPERANTO
Yes apologies, thats the one. -
MMM-PIR since update not working.
Ive just installed the latest update and now the PIR sensor value is not resetting. I have to mouse click to get the screen to recover once blanked.
Touchmode 0 disabled
Mode 4 -
RE: MMM-PIR
Thank you, I’ve checked and it is mode 4 for HDMI CEC, I have checked my monitor and HDMI CEC function is turned on, so it should work. After time out the monitor blanks but it is still powered on so I’m guessing so is the backlight, but Ill wait till dark to find out.
Can I just say thanks again for your support with this. -
RE: MMM-PIR
@sdetweil
Many thanks, when I shut down the Pi, I get a No Hdmi message on screen and then the monitor goes into standby.
Is there a way that MMM-PIR can turn off the Hdmi feed?
Apologies but I’m not a programmer, just a hobbyist, you mention CEC commands, how would I implement this? -
MMM-PIR
Having had issues with Pi5 I went back to Pi4b. MMM-PIR works great with pi 4, blanking the screen after timer expires and resetting once presence is detected.
The only issue I have is when the screen is blanked, the monitor backlight remains on, visible at nightnas a glow, the monitor remains powered up, I would have expected it to go into standby? -
RE: Issues with MMM-PIR
@schris88
Thx for the info, I guess a lot of the modules require reworking for the Pi 5.
Unfortunately I do not have the ability, totally new to the Pi and programming. -
RE: Issues with MMM-PIR
@eyesallin
I’m beginning to think that all this is Pi 5 related.
Also changing to mode 10 as previously stated screws with the weather modules which don’t load. Remove MMM-PIR from config and everything works fine.
It doesn’t help that I’m completely new to all this.