And so can the rest of the world.

0.0.0.0/0

@strawberry-3.141 I’ll be getting radiator thermostats in the next few weeks but no cooling

@sdetweil what do you mean? I have a small magic mirror in my private office. Instead of opening my phone to see codes they could be displayed on the mirror

What do you mean? If you use 2FA you’ll be familiar with the concept of codes being displayed

I don’t mean that, I mean that it displays the Authenticator codes for other platforms, like Facebook, Google, Amazon codes. Like the Google and MS Authenticator apps do.

I’ve been wondering if it’s a good idea having the MM display 2FA auth codes?

And so can the rest of the world.

0.0.0.0/0

YOu have to spend a while sending webhooks requests, then compile a list and whitelist.

IFTTT uses amazon AWS so it could be a massive list of addresses.

Worked fine on my mirror on a Pi3B. Just had to remove some of the final commas from the config

@scooter did you write the software yourself?

The reason why “/24” works
A couple different threads state to add /24 to the end of the IP address. (I’ve put a couple of those up before doing some research too). While this will indeed allow your network devices access to your magic mirror, it will also allow any device with an IPv4 based address access to your mirror (obviously your router would need to be configured to allow this).
This “/24” in IPv6 CIDR allows 20,282,409,603,651,670,423,947,251,286,016 different IP addresses access. (IPv4’s total addresses are 4,294,967,296).

---

More information
If you’d like to learn more or have different sub-netting needs, I found this page useful.

I don’t ageee with that. 192.167.1.0/24 is everything in the 192.168.1.x range, nothing more nothing less. If it allows more than this is a massive flaw/security risk.

If you want to allow your own subnet then just look at your subnet mask and use google to get the CIDR

I think this is one of the best modules I’ve seen in a long time - now… how do we get developers to add support?