@sdetweil
Thanks for all your help.
One quick question. I have security cameras that stream ffmpeg. Is there module that will display just one of these camera’s output?
Cheers.
Glenn.

Sam. It took quite a while to get my usb stick programmed, updated and configured but my MagicMirror is up and running thanks to you. Excellent work on the script!!
Now it is off to customize it. What fun…

Sam. It finished and when I restarted PM2 the browser did not come up.
I’ll remove the stretch sd card and start over with the Buster desktop sd card. Then it should work.
This will take a while.
Thanks for all your help.
Glenn.

Thanks Sam.
I’m just finishing installing chromium. Let me see if it works. My version of Stretch is NOT the desktop version. I have a version of Buster however that is the desktop version. If this still fails after the chromium install, I’ll redo it with the Buster sdcard.
Will your install script also work with Midori browser?
Glenn.

I currently have stretch lite loaded on my SD card. The install script worked just fine and the pm2 start MagicMirror shows MagicMirror status online. However, there doesn’t seem to be a browser page come up. I still seem to be in CLI mode. Should I start it all over from scratch with Buster?

Thanks for replying so quickly sdetweil. Where does this leave me in the installation process when it is done?

I’m new here and I"m looking for an up to date installation procedure to put magic mirror 2 on my raspberry pi zero w. I’ve looked at several on the internet and most have really old code. They are still using jesse in most cases. Also, when following weiber and rootsudo they are saying to run “sudo wget http://node-arm.herokuapp.com/node_latest_armhf.deb” and the node_latest_armhf.deb comes back with a 502 Bad Gateway error. I’ve verified this several times.
So, I really like magic mirror and want to get my raspi zero w going with it but I’m kind of stuck with old install information. Any help would be greatly appreciated. Glenn.