Up to date install process.

sdetweil · Mar 23, 2020, 2:09 PM

@stampeder use the install script from here

https://github.com/sdetweil/MagicMirror_scripts

stampeder · Mar 23, 2020, 2:25 PM

Thanks for replying so quickly sdetweil. Where does this leave me in the installation process when it is done?

sdetweil · Mar 23, 2020, 2:28 PM

@stampeder with a running MM, with pm2 to start on boot (if u select that during the install process)
and screen saver turned off (if u select it)…

i suggest u start with raspian buster, not jessie (too old)

my repo is referenced from the MM doc site

u will need to remove any existing MM folder before starting

if u choose not to do the optional things, there are scripts on the same site to enable them later

stampeder · Mar 23, 2020, 2:31 PM

I currently have stretch lite loaded on my SD card. The install script worked just fine and the pm2 start MagicMirror shows MagicMirror status online. However, there doesn’t seem to be a browser page come up. I still seem to be in CLI mode. Should I start it all over from scratch with Buster?

sdetweil · Mar 23, 2020, 2:33 PM

@stampeder pi 0w should have the chromium browser started to show the page…

u have lite installed, which probably doesn’t have chromium… so I would install that and then restart MM using pm2

sudo apt-get install chromium-browser

sdetweil · Mar 23, 2020, 2:34 PM

@stampeder the system is running the graphical desktop, right? it must

stampeder · Mar 23, 2020, 2:43 PM

Thanks Sam.
I’m just finishing installing chromium. Let me see if it works. My version of Stretch is NOT the desktop version. I have a version of Buster however that is the desktop version. If this still fails after the chromium install, I’ll redo it with the Buster sdcard.
Will your install script also work with Midori browser?
Glenn.

sdetweil · Mar 23, 2020, 2:44 PM

@stampeder it MUST be desktop version… else u will run in serveronly mode and can access from another system

electron or chrome needs the graphical desktop environment to work

sdetweil · Mar 23, 2020, 2:45 PM

@stampeder the install script is bash… running is a different problem…

u will have to change the run-start.sh script to launch that browser

stampeder · Mar 23, 2020, 2:48 PM

Sam. It finished and when I restarted PM2 the browser did not come up.
I’ll remove the stretch sd card and start over with the Buster desktop sd card. Then it should work.
This will take a while.
Thanks for all your help.
Glenn.