Read the statement by Michael Teeuw here.
MMM-Remote-Control Error After Accessing From Browser After Installation
-
I just installed and configured the MMM-Remote-Control Module. I tried accessing it from my phone and from a different computer after I added the IP addresses to the whitelist. On both systems, I get the following error:
{“status”:“error”,“reason”:“unknown_command”,“info”:“original input: {}”}
That is the only line that shows up in the browser. Any advice?
-
Hi schwarem,
Old post I know.
Did you ever find a solution as I have the same problem? -
@rudiau on your pi, by default, mm is set to NOT allow other system to access
you need to change the mm config.js settings
address:“0.0.0.0”
and
ipWhitelist:[]to allow any system (computer, phone, tablet) on your local network
-
Thanks for the reply Sam.
I had done that which you instruct.
My problem, I just found, I had forgotten to add “.html” at the end as in “http//:192.168.xx.x:8080/remote.html” which threw this error message:- {“status”:“error”,“reason”:“unknown_command”,“info”:“original input: {}”}
Thank you.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login