Dell Monitor 19" 1905FP for my Magic Mirror

[kusselin]

so, i screwed the monitor open und i took some photos. i hope this is o.k. so.

Is this a 40 pin connector?

for a link what controller panel i can use, thanks a lot.

[lolobyte]

@kusselin

Hello Friend.

here some links for your panel:

Important:

search for version v.1: M190EN03 V1
You also need a power adapter (Ouput 12V/4A) for it.

ebay

AliExpress

good luck

[kusselin]

@lolobyte said in Dell Monitor 19" 1905FP for my Magic Mirror:

M190EN03 V1

thanks very much

[kusselin]

one more question about the power supply …

if the voltage were higher … would the controller break? Does it have to be exactly 12V / 4W !!?

I can supply the Raspberry Pi with power with the MicroUSB on the USB on the controller … right?

Is the power adapter big for a connect to the pi?

[lolobyte]

@kusselin

Hi, Friend.

Yes, you need two power supplies!
The standard one 4 the Raspberry pi 3 (5V/2,5A) or (5V/3A) for version pi 4.

For your panel you need the 12 V/4A (ampere) not 4W (wat) power supply.
4W ist to poor power. This one has 12*4=48W

Please read “Instruction to connect the controller board to the LCD” for example in the board specs at ebay.

Best regards

[kusselin]

@lolobyte said in Dell Monitor 19" 1905FP for my Magic Mirror:

Hi, Friend.
Yes, you need two power supplies!
The standard one 4 the Raspberry pi 3 (5V/2,5A) or (5V/3A) for version pi 4.
For your panel you need the 12 V/4A (ampere) not 4W (wat) power supply.
4W ist to poor power. This one has 12*4=48W
Please read “Instruction to connect the controller board to the LCD” for example in the board specs at ebay.
Best regards

Hi with this controller you need only one power supply…

[lolobyte]

@kusselin

OK, much better…
:-)