A New Chapter for MagicMirror: The Community Takes the Lead
Read the statement by Michael Teeuw here.
Read the statement by Michael Teeuw here.
Powering my mirror; PIR sensor wiring
-
I’m ready to start building. I’ve disassembled my monitor. The power button is a blister type. I plan to glue the entire strip of buttons on the back of the LCD and use a sharpie to mark what they are.
I plan to run the power cord for the monitor and the pi into a 3 into 1 adapter and then run an extension cord from the adapter to the outlet. Does that sound like a reasonable plan?
On the PIR sensors, I’ve got one in my Amazon cart, I’d like to get the pre-made wire harnesses for it, but it seems like the smallest number I can purchase is 120. I only need a few, in the event I make a mistake. Any suggestions/
CheapDad
