Read the statement by Michael Teeuw here.
How I got my Magic Mirror working on a Raspberry Pi 0 (zero)
-
@piziie That sounds right. Without tracing too closely, it sounds like your
startMagicMirror.shscripts and yourstart.shscript are both starting the mirror process. -
@bhepler after deleting startMagicMirror.sh the same problem exists
-
@piziie After you deleted the
startMagicMirror.shdid you run the update command you quoted?
sudo update-rc.d startMagicMirror.sh remove
(more information at the the update-rc man page) -
@bhepler i have run that command, same issue persists.
Could it have something to do with VNCserver? -
I have MM2 running quite well on my Pi3 but I’d like to free up the Pi3 and use my zero for the MM2. Has anyone seen any real downsides to using the Pi Zero over the Pi3?
-
@Mar compared to the Pi3 the processing power is way lower, so from that point of view some modules wouldnt work properly. That said, for the ‘stock’ modules and API driven modules it should all work fine. Besides that the installing process is a bit more difficult as you can read above ;)
-
@Wieber Thanks, I would be using the Button module, PIR sensor module, Wunderlist module, and I want to try adding the Alexa module once i transfer it over to the Pi?
Another thing I was thinking would be to integrate this into my openhab setup to bring in the status of various sensors.
-
I have another question. How could i get into the terminal when the pi goes right into the browser? I cant ssh into it for some reason so is there anyway to exit the browser and go into the terminal?
-
@SebTota Try
CTRL+ALT+F2(note: I have not tried this myself, but it works on other systems I use) -
Yet another question. I tried all other forums but i cant find my answer so I figured id ask here. If i have jessie lite with just the terminal, can I open up a file explorer to copy and paste a folder. I need to copy two folders over but I cant figure out how to do it.
