Help with MMM-SleepWake

sdetweil

@chanster remove the word value from both lines in motion.conf

sdetweil

@chanster motion wakes up. timer puts to sleep

sdetweil

@chanster u can run the exteral_motion started command from the command line to test getting the commands working.

over ssh too. it’s just a command to tell module there was ‘motion’

chanster

@sdetweil Thank you !! I’m so stupid. Removing “value” did the trick ! Thank you for this module. Works perfectly.

sdetweil

@chanster glad u got it working.

help me fix the doc, what lead u to use value?

chanster

@sdetweil It was in the sample config file for Motion. It’s a rookie mistake that I should have replaced “value” and not merely append to this line :

# Command to be executed when an event starts. (default: none)
# An event starts at first motion detected after a period of no motion defined by event_gap
; on_event_start value

# Command to be executed when an event ends after a period of no motion
# (default: none). The period of no motion is defined by option event_gap.
; on_event_end value

sdetweil

@chanster ok, my module doc gives u the new lines for motion.conf

chanster

@sdetweil said in Help with MMM-SleepWake:

@chanster ok, my module doc gives u the new lines for motion.conf

Yes, nothing wrong with your docs at all.