MMM- Remote Control help

[Nneuland]

@sdetweil
Thank you for the reply. After adjusting the address to “0.0.0.0” and adding my IP, I’m in a holding pattern of blank screen and curser, and no connection to the http://192.168.xxx.xxx:8080/remote.html website.

“This site can’t be reached”

[sdetweil]

@nneuland did u remove everything from ipWhitelist?

[Nneuland]

@sdetweil

This is what have in my ipWhitelist

ipWhitelist: [“127.0.0.1”, “::ffff:127.0.0.1”, “::1”, “ffff:192.168.XXX.XXX”], // Set [] to allow all IP addresses

I have xxx’d my actual ip address.

[sdetweil]

@nneuland 1st let’s take everything out

[Nneuland]

@sdetweil

Thanks for the help. []

This site can’t be reached192.168.xxx.xxx took too long to respond.
Try:

Checking the connection
Checking the proxy and the firewall
Running Windows Network Diagnostics
ERR_CONNECTION_TIMED_OUT

[sdetweil]

@nneuland can u connect to mm

http://ip:8080

[Nneuland]

@nneuland sadly no

This site can’t be reachedCheck if there is a typo in ip.
If spelling is correct, try running Windows Network Diagnostics.
DNS_PROBE_FINISHED_NXDOMAIN

[sdetweil]

@nneuland ok, so it’s a networking problem

u said windows… I always turn off the firewall for a while

[Nneuland]

@sdetweil

Thanks Sam. Oddly turning off firewall is yielding the same results.

Not sure the problem…

[sdetweil]

@nneuland had someone the other day have pi on guest wifi while phone was on family wifi…