Read the statement by Michael Teeuw here.
Update a module whit git pull didn't work...
-
ok i have tested it now again. after i write git pull my pi write this…
remote: Counting objects: 24, done.
remote: Compressing objects: 100% (10/10), done.
remote: Total 24 (delta 11), reused 9 (delta 9), pack-reused 5
Entpacke Objekte: 100% (24/24), Fertig.
Von https://github.com/MichMich/MagicMirror
5d63065…9bd42ac develop -> origin/develop
Already up-to-date.And because this link i think it like to update mm² and not the module. https://github.com/MichMich/MagicMirror
-
@gismo2006 I think I am actually having a similar issue as you. I updated the same module last night using git pull, but the module is not functioning properly. @strawberry-3-141 any chance we need to npm install inside the folder again?
-
@strawberry-3-141
I have to lie to answer this question.
I think i have install it with git clone. but iam not realy sure. but i think you are right that can be the misstake… :-)
greets gismo
-
@Burner911 only if the dependencies have changed
-
Okay I have a new Problem. Because git pull didn’t work, i Download the git Repo as an zip file and extract into my module folder. I change the name to the correct module name and rename the old remote Modul folder. Then I restart mm2 and I only see a white page and my pi crashes. But I remember i have seen this Problem in this forum in a post too. But now I’ll decide to go sleep i will check this tomorrow.
So good night good morning or whatever is right now :-)
-
@gismo2006 well, you will have the same problem again next time when you have downloaded it manually
did you install the dependencies?
-
@strawberry-3-141 i think I have, because it works fine till this update. But I found maybe a solution in this post: https://forum.magicmirror.builders/topic/1561/white-screen-after-mmm-remote-control-update/7
I will test it later…
-
This post is deleted!
