MMM-Hue CORS Policy Issue

karsten13

This could be caused by the new electron version if you are running this on a raspberry pi.

If so you could test adding electronOptions in your config.js like:

let config = {
	electronOptions: {
                webPreferences: {
                        webSecurity: false
                }
        },
	address: "localhost", 
	port: 8080,

Fozi

@mumblebaj I have the same issue with the same error, but with MMM-Homematic since the update to MM 2.18. MM cannot connect to my CCU2 controller to get the device statuses.
@karsten13 your proposal unfortunately didn’t work :-( But thanks anyway!

karsten13

@fozi I have no test setup so this is difficult without …

Fozi

@karsten13 No worries! I just wanted to let you (and others) know that the config entry does not solve the issue.
I made a little research around CORS and -at least for me- it doesn’t seem to be trivial to configure electron in a way that specific origins are allowed without disabling the CORS policy completely.

Anyone around with more knowledge?

karsten13

@fozi

found this one https://pratikpc.medium.com/bypassing-cors-with-electron-ab7eaf331605 which could be tested in js/electron.js.

mumblebaj

Thanks @karsten13 , seems like it does not work as mentioned below by @Fozi . Seems like the modules uses jQuery and does a call to the bridge to get the data. Seems like I need to log an issue on Github for the module but it has not been touched in the last 3 to 4 years. I will fork it and see if I can make some changes to get it working. The last suggestion you made below seems like code changes module side so I will see what I can do to change it from jQuery to something that would work. Thanks for the replies.

karsten13

@mumblebaj

you can test the following, I couldn’t test this completely but the cors error was gone in my tests.

First yo need to create own certs, go into the config folder of mm (same folder where config.js is located) and run this command:

openssl req -newkey rsa:4096 \
            -x509 \
            -sha256 \
            -days 3650 \
            -nodes \
            -out example.crt \
            -keyout example.key \
            -subj "/C=DE/ST=Hessen/L=Frankfurt/O=MagicMirror/OU=MM/CN=www.example.com"

Then edit your config.js and add the following lines under the line with var config = {

	electronOptions: {
		webPreferences: {
			webSecurity: false
		}
	},
	useHttps: true,
	httpsPrivateKey: "config/example.key",
	httpsCertificate: "config/example.crt",

(Re)Start mm and test if MMM-Hue works now (there will still be a “mixed content” warning).

mumblebaj

@karsten13 Awesome. That worked. Much appreciated for the assist.

Fozi

@karsten13 You are a genius! That worked for me, too! Thanks so much!

karsten13

@fozi thanks but … no

would be better to have a solution without https, may someone else gets this figured out.

As an improvement for the above solution with https:

Holding the certs in the config directory makes them accessible from outside so better move them into a new directory beside config, e.g. certs which is not exposed. Don’t forget to update config.js afterwards.