Read the statement by Michael Teeuw here.
Having trouble with screen on and off? Here are some tips that could help
-
Works great, but when the monitor switches back on, chromium does not start maximized and shows the infobar, both of which are managed in the [autostart] section of wayfire.ini. Is there a way to get the MM display back just as when the Pi launches fresh?
-
@langejos switch back to x11 in raspi-config
-
For me I needed to use wayland-0 on a RPI5 using the ribbon-display cable.
From the wlr-randr i got thisDSI-1 “(null) (null) (DSI-1)”
Physical size: 154x86 mm
Enabled: yes
Modes:
800x480 px, 60.028999 Hz (preferred, current)
Position: 368,332
Transform: 90
Scale: 1.000000So I used DSI-1 instead of HDMI.
Also I removed the --mode information since i got something like “Mode 800x480 not recognized”, but apparently my display defaults to that. -
@mumblebaj Course, I just switched back to X11 for now. 🙃
-
-
Hello all and thank you for all the suggestions. I apologize as I never got followup notifications of your responses.
I ended up reverting back to the original desktop as I did not feel like fighting to change everything.
Again, thank you all for your time and help.
-
@sdetweil Yes, I did! I tried switching to x-11 and adjusting all parameters, but ended up switching back to wayland which works fine with a scheduled shut-down in the evening. Thank you once again for taking the time to lead me through this!