MMM-Config with Message "builder encountered a problem, see MagicMirror messages for info"

sdetweil

@dphotograph also, do you know the rough change you made last? installed a module?

dphotograph

@sdetweil

i think the last ones are

MMM_homeassistant_sensors
MMM_HomeAssistantDisplay
MMM_SteamPlaytime

Unfortunately, I was too impatient and installed three modules at once.
Typical beginner’s mistake

dphotograph

@sdetweil

i just removed the Steam Playtime from MM now it is back to normal :-)

i think i can live without it ;-)

But really! Thank You for the help to indentify the Problem :-)

sdetweil

@dphotograph thanks the discovery of all the module config contents is pretty tricky

ill look at this shortly

sdetweil

@dphotograph did you install the modules thru the MMM-Config installer?

sdetweil

@dphotograph you should have seen this in the logs, MagicMirror
startup messages

--------------------MMM-Config
module MMM-SteamPlaytime has an error in the construction of its defaults section
the error line is 		language: "---!config.languag"e
please change it to the literal value of the referenced variable
and restart MagicMirror
--------------------MMM-Config

because you are using pm2, you will have to ask to display more lines of output than the default 15
for example

pm2 logs --lines=100

100 can be any number, default is last 15…

sdetweil

@dphotograph you can use that module again now

in the MMM-Config folder do
git pull
then restart MagicMirror