Read the statement by Michael Teeuw here.
MMM-PIR-Sensor problems
-
Have you tried to set the timer potentiometer (Haltezeit in your picture) on the PIR-sensor to minimum? I have the very same PIR-sensors and they are working very well without any additional resistors.
-
Ok, think, it is working… not perfectly, but working.
Could you take a picture of your potent meters AND jumper ?
Have set them both to the left position. Would help a lot.A lot of people are walking the way the mirror is mounted to the wall. Finally, I would like the mirror to switch on if a person stays in front of it for 10 seconds. Don’t know exactly how to do this.
At the moment it switches on in 1 second.
-
@blebbens
That’s a picture I took before mounting it to the wall. Taking a new picture will be a bit difficult now. Hope it helps.
Btw, I don’t use the MMM-PIR-sensor module. Initially I did though and I didn’t change the jumper. The sensor is set to “high”, in case it’s not clear from the picture. -
I put the potentio meters to the left position - like in your picture.
The screen switches on in seconds… looking for a possibility to turn it on if someone stands in front of the mirror for 10 seconds.
Using MagicMirror-Display-Controller instead of MMM-PIR-SENSOR.
Hope, this could be done using right “time” potentio meter. Not sure.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login