I just got my mic from Amazon I am looking to get Google Assistant to work with my mirror. My main reason for this is to ask GA to play my favorite morning radio show from iHeartradio(which my current Google Home speaker can do). In the future I would like GA to configure what modules are displayed on the mirror also.
I am new to pi and have some noob questions…What is the difference between installing GA on the pi outside of MM and installing the MMM-Google Assistant module? Can either way give me the same results?..and also if I already have a GA speaker in my house is doing either of these redundant and unnecessary?
As of right now I can use GA on my phone to show or hide modules on the mirror using MMM-Remote Control, Tasker, AutoVoice and AutoInput. Its a bit clunky but works for now…I’m thinking GA integration of some kind would be better???

@yawns Thanks…I tried changing the resolution but it didn’t take…tried it a second time and its ok now.

I am very new and still learning…yesterday I entered display_rotate=1 in config,txt file to see if I could rotate the display(just to see if I could)…it worked so then I deleted it and shutdown the pi. Today when I boot the pi its resolution is changed and the fonts are all too big in the pi desktop and the Magic Mirror. All I did was add rotate and remove it. Here is my config.txt

#hdmi_mode=3

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

# NOOBS Auto-generated Settings:
#hdmi_force_hotplug=1

@cruunnerr Thank you…it works now.

I cannot get this to work also…I have added my PC and my phone to the white list, but both say it refused to connect. My “var config” is set to “localhost”…do I need to change that to something else…I am not sure what that part is asking for.