My first Magic Mirror build using a recycled 19’’ TFT monitor. [image: magic_mirror_final_cropped.png] You can read a super detailed guide to building a Magic Mirror, including tips for setting up your JavaScript development environment, how I calculated the measurements for the different frame components, and even download my 3d modeling files for the mirror housing here: https://fairhurst.dev/portfolio/mirror You can view the configurations for my modules here: https://github.com/fairhurst-dev/MagicMirror My housing design consisted of the frame, followed by the two-way glass and monitor stacked on top of each other. This stack was surrounded by the dummy box and finally a plywood back board was attached to the back. [image: labeled_exploded_view.png] I created a frame and dummy box using two 3-in x 6-ft pine boards. Then I attached the two-way glass to the back of the frame with silicone glue. [image: frame_with_glass.png] I secured the monitor inside the dummy box and flat against the glass using four 4-in corner braces. [image: corner_brackets.png] I attached the dummy box to the frame back using 1.5-in corner brackets. [image: side_view.png] The plywood backboard was attached using 2-in corner brackets, followed by a French cleat to allow the entire unit to hang on the wall, no stud needed![image: french_cleat_plywood.jpeg] Lastly, I used cable ties to organize the cords behind the monitor and velcro squares to secure the power boxes and Raspberry Pi to the back of the monitor[image: velcro_squares.png][image: back_view.png] Enjoy the build, and please reach out with any questions! https://fairhurst.dev