@emailuser said in IR Overlay - pulling hair out !:

DISPLAY=:0 xrandr --output HDMI-1 --rotate left

Thanks Sam … but those instructions are for a touchscreen – i have an IR USB overlay which enables touch on the screen ,
as an example on the instruction
Enter sudo nano /etc/modules at the command prompt to edit the file. Go to the line for the ads7846_device parameters and move the cursor to the right to find it: - i dont have that in that file

Hi everyone … i have built my MM frame and am using a old 32"LCD TV , sitting on top i have a 32" IR Touch overlay … but the overlay responds to touch in landscape mode - i have a pi4 and have rotated the TV screen using DISPLAY=:0 xrandr --output HDMI-1 --rotate left , but despite looking at loads of forums / websites nothing seems to work to make the touch overlay rotate as well … my overlay is Bus 001 Device 003: ID 1ff7:0013 CVT Electronics.Co.,Ltd CVTouch Screen (HID)

Any help greatly appreciated !!!

Hi , advice appreciated for a newbie , i have MM running on Pi 3B , i also have home assistant running on a different PI, i have added the above module and am able to display a sensor entity for bedroom temp, but it only shows the entity state as heat, i would like to show the actual temp, i beleive i might need to add an attribute in the config.js , but i have tried many combinations but all fail, here is example below of config.js
prettyName: false,
stripName: false,
debuglogging: false,
displayvalue: true,
values: [{
sensor: “climate.josh_bed”,
attributes: [
{“current_temperature”
{]

below is the states in HA … am i able to add these to MM ?