@sdetweil Yes it helped in resolving the issue. I still need to understand what troubleshooting actually helped.

@sdetweil said in Module error after updating - MMM-Pir: Pir Error detected: EINVAL: invalid argument, write:

python pir sensor test
I’m a newbie and this helped a lot! Thank you!

Hi everyone,

I just can’t get it to work guys. Please help.

GPIO setup:
VIN - Pin2
OUT - Pin6
GND - Pin11

Configuration:
module: ‘MMM-Pir’,
position: ‘top_left’,
config: {
debug: false,
delay: 1 * 30 * 1000,
mode: 1,
displayCounter: true,
displayBar: true,
displayStyle: “SemiCircle”,
displayLastPresence: true,
lastPresenceTimeFormat: “LL H:mm”,
xrandrForceRotation: “normal”,
wrandrForceRotation: “normal”,
touchMode: 2,
pir_gpio: 17,
pir_mode: 1,

I have been playing around with all variations and have tested 3 sensors. Not sure what I’m missing.
Thank you for your support!

Sorry everyone. It was my mistake. The other calendar had its first element to far in the future to show it. Thanks for the assistance! :)

@kckndrgn I tried the same and only the first (my personal calendar) is showing. Here is my text:

config: {
				calendars: [
					{
						symbol: 'calendar-check-o ',
						url: 'webcal://calendar.google.com/calendar/ical/........./basic.ics'
					},
					{
						symbol: 'calendar-check-o ',
						url: 'webcal://calendar.google.com/calendar/ical/en.hungarian%23holiday%40group.v.calendar.google.com/public.basic.ics'
					},
				],

Thanks in advance!
Laszlo

Note from admin: Please use Markdown on code snippets for easier reading!