@idoodler thank you very much again, will keep an eager eye out for this one!

@idoodler thank you very much again, will keep an eager eye out for this one!

@idoodler so just to clarify, this has been found and due to be fixed?
or did i totally misread that…

if so can’t wait for new release!

EDIT: pardon my manners, thank you for checking this out as well :)

@idoodler FYI default modules only it still shows the same, I have a bit more time tomorrow so I’ll try reducing one by one to see if i can find exactly which doesn’t work - though I feel it’s likely going to be all of them

@shiroe
EDIT: if someone can confirm how to fix the above with a direct image rather than just link I’ll edit original post and remove this one.

Hi all,

So to be as specific as possible in case it helps, I’ve setup MM on an RPi recently and have this working in the house in SERVER MODE.

This setup works successfully on Andriod/PC devices without issue.

However the iPad 2 (iOS 9.3.5) device I had lying around and target for this build actually wont show the page content, it loads in Safari/Firefox/etc and displays a black screen which I believe is the back ground colour but no content is visible (per below).

iPad Image [Imgur]

To test my setup I’ve checked using an iPhone 7Plus on iOS 10.2.1 which works, thus confirming it’s not an issue with Apple devices in general & just the iPad - or more likely the iOS release?

iPhone Image [Imgur]

If anyone has any ideas here I’d love any assistance at this point.
I’ve tried googling similar ios9.3.5 issues and checked the MM forum as well but can’t find any other mentions of this

EDIT: yes the port 8080 is there, Safari just hides it when you don’t highlight the address bar
EDIT2: iPad has been factory reset in case it helps, it’s also not jailbroken