Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

A New Chapter for MagicMirror: The Community Takes the Lead
Read the statement by Michael Teeuw here.

Question about building the mirror frame

7 Posts 2 Posters 4.4k Views 2 Watching

Log in to reply

C Offline

cowboysdude Module Developer
last edited by

I use two pieces of 3/4 pine to hold in the mirror and monitor so you should be fine using those.
M 1 Reply Last reply
Reply Quote 0
M Offline

monk @cowboysdude
last edited by

@cowboysdude Thanks!
1 Reply Last reply
Reply Quote 0
C Offline

cowboysdude Module Developer
last edited by

Pre-drill your holes first! :)
M 1 Reply Last reply
Reply Quote 0
M Offline

monk @cowboysdude
last edited by

@cowboysdude Holes for? Sorry not much of a handyman :(
1 Reply Last reply
Reply Quote 0
C Offline

cowboysdude Module Developer
last edited by

I’m assuming that you are using it on the back side of your frame to hold everything in…
M 1 Reply Last reply
Reply Quote 0
M Offline

monk @cowboysdude
last edited by

@cowboysdude Yes…So you mean the holes for adding the L shaped latch?
1 Reply Last reply
Reply Quote 0

Enjoying MagicMirror? Please consider a donation!