Read the statement by Michael Teeuw here.
MMM-AssistantMk2
-
@sun
OK. have you installed “MMM-NotificationTrigger” ?
Or give me a chat in this forum, or telegram me (@eouia) -
Not yet install mmm-notificationtrigger.
Do I have to install mmm-notificationtrigger as well?
I manage to get
[HOTWORD] << smart mirror >> is detected.
[HOTWORD] stop listeningbut when I say something. it won’t detect what I said. Only detect the hotword.
-
Got it done. Very nice. However, the sound is so lag. Might be because I run on rp3 and quite many modules in magic mirror.
-
@sun
Maybe. I always use BT speaker for my RPI and ATB. I cannot bear the crumpled sounds from analog or USB. -
This is fantastic thank you, I have got everything set up, it hears and responds (on screen) to every request - but unfortunately I get no sound (no speaking feedback), when a youtube video plays, the sound works fine, do I need to change the output device somewhere? I’m struggling to find the config for it.
-
@jomwells is there any suspicious errors?
-
@jomwells Are you using rp3 as magic mirror? I did get sound respond now and it really ugly. I do try both sound on tv via hdmi and from usb sound card. Assume that too much modules from magic mirror load.
-
@sean I would like to know more about MMM-Gaction regarding the deviceModelId - this should be done since register the device in mmm-assistantmk2. What about deviceInstanceId, where and how to?
-
-
@sun But In most cases, you might not need instance, because your mirror might be only one instance of your project. Instance is needed when action should select specific device for response. Try without instanceid first.
