Config.js example of MMM-Page-Selector & MMM-CalendarExt2 working together

[Keith]

@Monty I have the same problem with CalendarExt. Try viewing the mm using a browser, this caused my calendar to show up on mm and in the browser. Not the answer but might lead you to a solution.

Keith

[Monty]

@Keith Thanks for the response. I have tried with browser and even after allowing everything in the whitelist it still doesn’t allow connections via the browser (connection refused) Similar to other peoples experiences on the forum.

I will raise an issue on the Github page and refer back to here.

[sdetweil]

@Monty what is the setting in config.js for address:

[Monty]

I had the whitelist as [] which supposedly allows everything. I just changed it to this:

ipWhitelist: ["::fff:0.0.0.0/1", "::fff:128.0.0.0/2", "::fff:192.0.0.0/3", "::fff:224.0.0.0/4", "127.0.0.1", "::ffff:127.0.0.1", "::1"],

That works and I am able to browse localhost. I think it’s a different issue to you though because Ext2 still doesn’t show for me in the browser.

Thanks

[sdetweil]

@Monty but u didn’t answer on address: you answered on whitelist.

if the address is ‘localhost’, then only apps on this same machine can connect
whitelist is another problem. leave it open until u solve the problems…

	address: "", // Address to listen on, can be:
	                      // - "localhost", "127.0.0.1", "::1" to listen on loopback interface
	                      // - another specific IPv4/6 to listen on a specific interface
	                      // - "", "0.0.0.0", "::" to listen on any interface
	                      // Default, when address config is left out, is "localhost"
	port: 8080,
	ipWhitelist: [],

[Monty]

Address is set to localhost:

address: "localhost"

The developer responded about the issue:

https://github.com/eouia/MMM-CalendarExt2/issues/43

[lawrence_jeff]

I have it working but I don’t think you can do what you are trying to do in your config, CalendarExt2 overwrites everything so what I did was keep it in the same place on every page and then adjust the items around it. That is the only way to make it work - you can’t have it it one place on page one, try to change the view on page two

Start with a simple two page rotation with all the same modules showing (in the same places). Make sure it shows as the pages rotate