MMM-GoogleAssistant problem with .asoundrc

sdetweil

@RIKKO14 we are not selling mm, so not commercial use. you are adding a module to your personal system ( unless YOU intend to sell it)

I don’t know about the older module. only that @Bugsounet has done a lot of work to get it going

A Former User

@RIKKO14 said in MMM-GoogleAssistant problem with .asoundrc:

The MMM-GoogleAssistant of @Bugsounet doen’t work

je ne savais pas que je fesais des module qui ne fonctionnait pas ;)
Merci toutefois de me l’apprendre :)

“By terms of Google Assistant SDK, You are not allowed to use or provide this module for commercial purpose.”

cela veux simplement dire qu’il n’est pas permis d’utiliser ce module a des fin commerciale

RIKKO14

@Bugsounet TOUTES MES PLATES EXCUSES !!! J’avais donc mal compris, vraiment désolé…
I continue in English because it is required here (and that you will understand that I all pages and tutorials read with google translate …):
But then why in the page of your MMM-GoogleAssistant there is only the link git@github.com: bugsounet / MMM-GoogleAssistant.git and not all the description to install MMM-GoogleAssistant ?

A Former User

It’s on wiki page …

just read ;)

It’s write on Readme page

RIKKO14

Great, thank you !
So can you confirm me the card and device for my mic and headphones ?

A Former User

It’s depend of you device.
It’s the job of micConfig check at the end of install

Attention:
you share some personal data in your config.
You can have some takeover
Don’t forget … it’s a forum ! everyone read this !

RIKKO14

I tried to edit my 1st post but I can’t: “You are only allowed to edit posts for 3600 second (s) after posting”.

in the case I published which is:

**** Liste des Périphériques Matériels CAPTURE ****
carte 1: USB [WordForum USB], périphérique 0: USB Audio [USB Audio]
  Sous-périphériques: 1/1
  Sous-périphérique #0: subdevice #0
pi@raspberrypi:~ $ aplay -l
**** Liste des Périphériques Matériels PLAYBACK ****
carte 0: b1 [bcm2835 HDMI 1], périphérique 0: bcm2835 HDMI 1 [bcm2835 HDMI 1]
  Sous-périphériques: 4/4
  Sous-périphérique #0: subdevice #0
  Sous-périphérique #1: subdevice #1
  Sous-périphérique #2: subdevice #2
  Sous-périphérique #3: subdevice #3
carte 2: Headphones [bcm2835 Headphones], périphérique 0: bcm2835 Headphones [bcm2835 Headphones]
  Sous-périphériques: 4/4
  Sous-périphérique #0: subdevice #0
  Sous-périphérique #1: subdevice #1
  Sous-périphérique #2: subdevice #2
  Sous-périphérique #3: subdevice #3
pi@raspberrypi:~ $

my mic in on card 1, device 0 because " Liste des Périphériques Matériels CAPTURE", and my 3.5 jack headphone is on card 2, device 0 because " Liste des Périphériques Matériels PLAYBACK" , and in card 0, device 0 it’s HDMI.

is it correct ?