Installing on a Pi Zero

[sdetweil]

@akz_g yes, see the links in my signature for learning

[eracerhead]

@andyc7687 I know this is almost 2 years later, but this did not work on the pi zero w. I got to the point of on page 18 where it was supposed to say MagicMirror running. But it never did. It did say it was installed correctly, and to reboot, which I did, but it isn’t working.

$ pm2 show MagicMirror
[PM2][WARN] MagicMirror doesn’t exist

I don’t even know how to begin to troubleshoot this. (This was my second attempt at trying to install magic mirror.)

[sdetweil]

@eracerhead use my script
see here for instructions
https://github.com/sdetweil/MagicMirror_scripts

remove the MagicMirror folder

[camcooper151515]

I can say as of November 6 2020 the script works for installing the MagicMirror and auto starts on raspberry pi 0w. But… I do have some questions. How do I go about stopping the mirror so I can install modules? I’m a complete newb at this

[camcooper151515]

I can say as of November 6 2020 the script works for installing the MagicMirror and auto starts on raspberry pi 0w. But… I do have some questions. How do I go about stopping the mirror so I can install modules? I’m a complete newb at this

[sdetweil]

@camcooper151515 minimize
alt-spacebar, n
then alt-ctrl-t to open a terminal window, them the pm2 command

pm2 stop 0, or MagicMirror

[camcooper151515]

@sdetweil thanks I’ll try when I get home in the morning. Thanks so much for a working install I was at my wits end trying to get this to work until I found this thread. May I ask one more thing of you? Is there a command sequence I follow to stop the blanking of the screen after a few minutes for you install?

[sdetweil]

@camcooper151515 it should have asked if you wanted to disable screensaver.

anyhow, on the same site as the install script there is a command to turn it off now, down near the bottom of the page

[camcooper151515]

@sdetweil thanks that worked again. Is there a reason that my weather is not showing by default? Does it have to be setup first before it shows?

[sdetweil]

@camcooper151515 yes, some setup. needs to.know where u are for sure. some providers need u to register to request data