Read the statement by Michael Teeuw here.
Raspberry Pi 4 Released !
-
@SH20192 are you using any cooling system and if yes what? :)
-
@Cr4z33 said in Raspberry Pi 4 Released !:
@SH20192 are you using any cooling system and if yes what? :)
Yes, a small fan on an open plexiglass case. No heatsink. Without the fan it would complain about overheating.
Should mention it’s running 4 RTSP streams.
-
@SH20192 MM system works without changes on Raspbian Buster with the new kernel?
I’m positively surprised…
Gotta order a second one. Lol! -
@lavolp3 said in Raspberry Pi 4 Released !:
@SH20192 MM system works without changes on Raspbian Buster with the new kernel?
I’m positively surprised…
Gotta order a second one. Lol!Can I just upgrade the Pi 3 to the Buster OS so i can just swap the ssd over. Can someone confirm if it’s a plug and play boot from OS on an SSD? Rather than through the bios bit to enable it. Really looking forward to this PI I might get a heat sink but I want a big one not the little ones, need to see if I still have the one from the sky box, got a fan already for it but only activates when the TV is on
-
@lavolp3 said in Raspberry Pi 4 Released !:
@SH20192 MM system works without changes on Raspbian Buster with the new kernel?
I’m positively surprised…
Gotta order a second one. Lol!Except for the one module mentioned above everything working for me on Buster. Haven’t looked at logs or anything to see if there are errors being thrown that I don’t notice but so far so good.
-
@SH20192 I see.
I will start with an old Intel heatsink.
I got very good cooling results with a Rock Pi 4 B so I don’t think it will be any worse hehe.
-
@Cr4z33 said in Raspberry Pi 4 Released !:
@SH20192 I see.
I will start with an old Intel heatsink.
I got very good cooling results with a Rock Pi 4 B so I don’t think it will be any worse hehe.
Would that even fit on the Pi?
-
Unfortunately didn’t make it 24 hours of being up. :(
-
@SH20192 said in Raspberry Pi 4 Released !:
Unfortunately didn’t make it 24 hours of being up. :(
Nooooooooooo with that spec I wouldn’t have thought there would be any problems 🤦🏾♂️😢
-
@dazza120 ouch correct. :smiling_face_with_open_mouth_cold_sweat:
On the other board I could place it on the bottom side while on the Rpi you can’t.
