Read the statement by Michael Teeuw here.
LCD not Displaying
-
I am new to Magic mirror, i am building magic mirror from old laptop LCD 15.6" panel
after connecting the screen I see the LCD is lit as follows & not replicating the screen
White banding all around & no display content seen
I have the following Panel:
http://www.panelook.com/modeldetail.php?id=2160&fbclid=IwAR3Fdh0ZYUOI4p07lju-r3EklabRbrEYNVNUFzieq2QfYiKVSOZ1FGWCQTEMy LCD Controller board : Model No: hdvx9-as v4.2 (https://www.kazmielecom.com/2018/10/12/hdvx9-as-v59-software-free-download.html)
I have set the jumper to 3.3 V (As per panel & Board datasheet)
I have set resolution setting to 1366x768
Laptop Old LCD was working fine in the laptop till i disassembled it. (So i dont think LCD has an issue)
https://imgur.com/FxOzW9s
Please help me to resolve the issue.
Thanks in advance. -
-
Do you have the LVDS cable? A 6bit-1CH LVDS has different pin population that for instance a 8bit-2CH. Vcc and GND are at different locations and a wrong cable could potentially fry your LCD.
I am on my phone without my glasses, so I can’t see very well but on the imgur picture it looks like a 8bit-2CH cable while a 1366 resolution seems more like 6bit-1CH (just a guess from my little experience with LCD panels, don’t take it as a fact).
Have you tried to hook it back up to the old laptop to see if it’s still working?
Also, have you flashed the right firmware for the controller board?
