Read the statement by Michael Teeuw here.
Update a module whit git pull didn't work...
-
@strawberry-3-141
I have to lie to answer this question.
I think i have install it with git clone. but iam not realy sure. but i think you are right that can be the misstake… :-)
greets gismo
-
@Burner911 only if the dependencies have changed
-
Okay I have a new Problem. Because git pull didn’t work, i Download the git Repo as an zip file and extract into my module folder. I change the name to the correct module name and rename the old remote Modul folder. Then I restart mm2 and I only see a white page and my pi crashes. But I remember i have seen this Problem in this forum in a post too. But now I’ll decide to go sleep i will check this tomorrow.
So good night good morning or whatever is right now :-)
-
@gismo2006 well, you will have the same problem again next time when you have downloaded it manually
did you install the dependencies?
-
@strawberry-3-141 i think I have, because it works fine till this update. But I found maybe a solution in this post: https://forum.magicmirror.builders/topic/1561/white-screen-after-mmm-remote-control-update/7
I will test it later…
-
This post is deleted!
