Update a module whit git pull didn't work...

[gismo2006]

@strawberry-3-141

I have to lie to answer this question.

I think i have install it with git clone. but iam not realy sure. but i think you are right that can be the misstake… :-)

greets gismo

[strawberry 3.141]

@Burner911 only if the dependencies have changed

[gismo2006]

Okay I have a new Problem. Because git pull didn’t work, i Download the git Repo as an zip file and extract into my module folder. I change the name to the correct module name and rename the old remote Modul folder. Then I restart mm2 and I only see a white page and my pi crashes. But I remember i have seen this Problem in this forum in a post too. But now I’ll decide to go sleep i will check this tomorrow.

So good night good morning or whatever is right now :-)

[strawberry 3.141]

@gismo2006 well, you will have the same problem again next time when you have downloaded it manually

did you install the dependencies?

[gismo2006]

@strawberry-3-141 i think I have, because it works fine till this update. But I found maybe a solution in this post: https://forum.magicmirror.builders/topic/1561/white-screen-after-mmm-remote-control-update/7

I will test it later…

[PeppaPigKilla]

This post is deleted!