Read the statement by Michael Teeuw here.
Screen turning off
-
@sdetweil I had the screen blanking off already and I did use you script to install it… It’s not just that the screen goes blank, it’s that the power on the monitor turns off also, so when the screen would wake up because of motion the power is still off on the monitor. I’m thinking it must be something in the monitor setup but I don’t find it… I thought there might be a command to keep the screen alive so the monitor wouldn’t turn off for lack of activity…
-
@N6NG ah, monitor
yes, u have an energy star compliant monitor.
when the input is turned off it MUST power off after 15 mins.unless the monitor supports the cec commands, there is no way to turn it back on programmaticly.
this is why I use a module that hides all the modules instead of turning off the HDMI port.
I even had a tv that powered off if it was display a blank screen. pain in the rear.
-
@sdetweil And which module is that Sam?
-
@N6NG I’m guessing it’s mm-Hide-All but can you tie that to the Pir sensor so it hides it with no motion?
-
@N6NG my MMM-SleepWake
can be triggered by pir(some other module reading pir), or camera
I use camera, didn’t have PIR when I started this journey…
-
@sdetweil Ok Sam… again thanks
Dennis -
@N6NG I have the MMM-SleepWake installed. I have the config.js installed. Now I have to tie it to the MMM-PIR-Sensor-Lite module.
I’ve got the 2lines in the config.js
But what is in place of the /external_motion start and end from the PIR module?on_event_start /home/pi/MagicMirror/modules/MMM-SleepWake/external_motion started
on_event_end /home/pi/MagicMirror/modules/MMM-SleepWake/external_motion ended -
@N6NG I also don’t understand how this would keep the Monitor from turning off after 15 minutes? I need to turn off the auto off somehow.
-
@N6NG no need for external if you use pir
mode is hide( hides all modules or shows all modules.) doesn’t turn off monitor
-
@N6NG the trick is to keep the monitor active enough to fool it into not triggering it’s eco feature.
