Conncting to MM from outside

Janne

Ohh, I think it is a upgrade problem with the mm.
It is not possible to access the mm anymore from outside according to the last two comments.

https://forum.magicmirror.builders/topic/5025/can-t-access-magic-mirror-via-http/10

Mykle1

@janne

If that is the case then you can always install an earlier version of MM. I would wait a bit to see if someone else has a solution for you. I’m pretty sure that issue was resolved or a work-around was found. Try doing a forum search for whiteListing.

Janne

Just to close the topic.
I can’t connect with Internet Explorer. But I can with Chrome.

Don’t know why, but I am a step closer to my goal.

Hope it can help other magic Mirror builders.

Graham Rich

I think I’ve been doing the same recently but I wanted to clarify what you meant by outside. The post and replies appear to assume you mean the local LAN (home network). Is this what you mean or are you trying to access this from a remote device or mobile not connected to you home WiFi.

If it the first, then I would confirm that I am using the same setting.

var config = {
address: “0.0.0.0”,
port: 8080

If this is remotely access from another domain, you will need to know your internet providers IP address for your router and setup your route access rules/forwarding.

Janne

@graham-rich
Hi,
Actually I tried local LAN and I also set up a fixed ip in router and tested it from another LAN. Same problem and same fix.

Graham Rich

@graham-rich said in Conncting to MM from outside:

var config = {
address: “0.0.0.0”,
port: “8080” // added quotes to port: “8080” to correctly reflect my version
// Not sure what your ipWhitelist is saying. For a test set it to
ipWhitelist: [], //You will want to tie this down a little later to prevent it from being too open. Something like [“192.168.1.1”] if you know you local IP address should help once you got it working

Graham Rich

I assume you have connected to your magicmirror via a terminal connection before to make sure its on the LAN and that you are using the same IP address with 8080 at the end. EG http:192.168.1.44:8080

sdetweil

i can connect to both my mirrors on the 2.4.1 version