Application not starting when OpenGL is enabled

Klinge

Re: [RasPi2] Application not starting when OpenGL is enabled

I have the same problem as described above. The MM does not start.

> sh run-start.sh

libGL error: MESA-LOADER: failed to retrieve device information
MESA-LOADER: failed to retrieve device information
MESA-LOADER: failed to retrieve device information
Starting MagicMirror: v2.5.0
Loading config ...
Loading module helpers ...
No helper found for module: alert.
Initializing new module helper ...
Module helper loaded: updatenotification
No helper found for module: clock.
Initializing new module helper ...
Module helper loaded: calendar
No helper found for module: compliments.
No helper found for module: currentweather.
No helper found for module: weatherforecast.
Initializing new module helper ...
Module helper loaded: newsfeed
All module helpers loaded.
Starting server on port 8080 ... 
Server started ...
Connecting socket for: updatenotification
Connecting socket for: calendar
Starting node helper for: calendar
Connecting socket for: newsfeed
Starting module: newsfeed
Sockets connected & modules started ...
Launching application.

And I have not a PIR Module installed too. The MM is absolute new installed and still nothing configured.

Does anyone have an idea why it does not start?

Thank you in advance

richland007

@klinge I think the appilcationstarts but on server mode only at least thats what it was doing on my case…go on a different computers webbrowser and type your mirrors RaspberryPi IP address and :8080 as the port number http://raspberrypiIP:8080 and see what you get.

I did not find a solution to it i just took OpenGL out of the equation and it works fine

Denis

A Former User

Try this
npm start — —disable-gpu
— is - -(dash twice.) I’m not sure disable or disabled. Try both.

Klinge

Thank you for your advice. I will try it on Monday

Klinge

I tried both. …disable-gpu unfortunately does not not bring any improvement. So I took OpenGL out of the equation and it works.

Anthony

I have the same problem. When OpenGL is enabled the application freezes at launching and I must unplug my pi from power and plug it back. I even tried to update electron to a newer version but I got another error there so I end up disabling OpenGL again.

A Former User

Just use serveronly (node serveronly) instead npm start.

Anthony

@sean Thank you for your fast reply. I’ll give it a try as soon as I get home and see how it goes.

rts58

Are you using pm2? I was having same issue, and was able to resolve by following pm2 setup process.

dazza120

OpenGL causes nothing but problems on the Pi I had to go back to legacy, full GL caused locked up the Pi causing black screen from the start of the MM, Fake GL caused MMM-voice not to work, so had to go back to legacy and all problems above gone