MMM-Nest-Status - New module for your Nest thermostats and protect smoke detectors!

[eawalker1]

@michael5r Nope, that did the trick. Thanks.

[michael5r]

@eawalker1 said in MMM-Nest-Status - New module for your Nest thermostats and protect smoke detectors!:

@michael5r Nope, that did the trick. Thanks.

Great :thumbs_up:

[costascontis]

thnx for your hard work ,i really like this module,but its not updating right.When i restart MM works fine for few hours and then stops updating.My token is working fine ,i use it also to my Openhab setup .Also my other modules are all updating fine.My config is :

{
                       module: "mmm-nest-status",
                       position: "top_center", // pick whichever position you want
                       config: {
                               token: "c.xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx",
                               displayType: "grid",
                               displayMode: "all",
                               thermostatsToShow: "all",
                               updateInterval: "60000",
                               showNames: true,
                               thermostatSize: "medium",
                               // ... and whatever else configuration options you want to use
                               }

[michael5r]

@costascontis You configuration looks fine - the updateInterval is set to 60000, so it’s only pulling data every 10 minutes.

What exactly do you mean that it “stops updating”?

[costascontis]

isnt updateinterval in ms?cause if it is then 60000 ms = 1min…

[michael5r]

@costascontis said in MMM-Nest-Status - New module for your Nest thermostats and protect smoke detectors!:

isnt updateinterval in ms?cause if it is then 60000 ms = 1min…

My bad - you’re right, it’s 1 minute :)

[nhl]

@costascontis Make sure the away read permission is active on your nest development OAuth client

[costascontis]

@nhl in my Other Permissions Away read is greyed out.

[michael5r]

@costascontis It shouldn’t matter - I don’t use the Away read setting in this module. The settings that matter are the ones directly tied to the thermostat and smoke detectors.

[costascontis]

@michael5r my Thermostat read is greyed out too …is that matter?