Hey guys,

I’m trying to get one of the PIR sensor modules to work however I’m running into the scenario where once the monitor has been successfully turned off, it turns back on after a few seconds and the “Check Signal Cable” widget starts floating around the screen.

I’ve tried both the MMM-PIR-Sensor and MMM-NewPIR modules and both run into the same issue a few seconds after the screen is turned off. I’ve tried the preventHDMITimeout config for MMM-PIR-Sensor but that doesn’t seem to help.

I have a feeling the monitor’s analogue on/off switch might be overriding the raspberry pi but that’s just a theory. The monitor is a Samsung S24B370 and I’m using the HDMI input.

Would anyone happen to have any tips?
Cheers